The J's Racing Front Camber Joint S1 allows for additional front camber by shifting the camber range to 2°-5° of camber without roll center adjustment. S2 allows for 3°-6° of adjustment.
By redesigning the previous model, this new camber joints includes 9mm of built in roll center adjustment in addition to the negative camber adjustment.
The front camber angle can be adjusted to the stock + 2 degree (+ 3 degree for S2).
The front roll center value can be adjusted back to the correct one.
The insufficient negative camber is always a problem for S2000. This product creates enough negative front camber by locating the lower ball joint at an eccentric angle from the center.
The product also corrects the front lower arm position back close to horizontal, so that the correct geometry is restored with the accurately adjusted roll center. [When you reduce the ride height, the front lower arm position becomes like a separated letter V]Recommended for S2000 vehicle height that is reduced more than 40mm.
* The stock bolts are to be reused or use new stock ones.
Please apply the correct tightening torque. After the installment, it is necessary to properly adjust the ride height and alignment. It is highly recommended to check the tightening condition of the bolt & nut periodically [Always check it before the track event or race].Features
Note: Roll center adjuster plate is NOT included with this kit.
- Forged aluminum construction with J's racing stamp
- Includes special bolts, nuts and clips
- Ball joint S45C
- Boll stud SCM435 HB195-260; fluctuation angle 33 degree all around
- S1 Kit - adjusts fronts 2-5 degrees
- S2 Kit - adjusts fronts 3-6 degrees
- Roll center adjustment: 9mm
- Sold in pairs